phone icon855-647-5944

We Bill Insurance!

Family Owned And Operated for over 20 years!

clock with 24 and 7 near the hands

60 Minute Response! phone icon 855-647-5944 Emergency Plumbing Help


Slab Leak Repair Burlingame



Think you have a slab leak in your Burlingame home or business? When it comes to Slab leak detection in Burlingame, 247 LeakMasters a local and family owned business is your go to solution. Using top of the line electronic leak detection equipment, we find the source and fix your leak and pipes, and repair any water or flood damage. Our expertise allows for us to repair your leak with the minimal amount of damage.

No need to call out a separate repairman, our plumbers are licensed contractors and can perform repairs in the same call! We are insurance specialists, working directly with your insurance company so you don’t have to.

We do not charge for call outs. Call us today to find out how your detection could be FREE! We can be with you in less than 60 minutes! In addition to fixing your slab leak we provide full service water damage restoration for Burlingame homes. If you think you may have a slab leak, don’t delay, call us today!

Slab Leak Repair in Burlingame

What is a slab leak?

Plumbing in most homes in Burlingame utilize copper piping underneath a concrete foundation. Copper pipes are know to be susceptible to developing cracks and holes as time goes on. This is what we call a slab leak. It is often difficult to find the source of the leak because the pipe is hidden in the slab and water can escape slowly over time. Slab leaks can cause substantial damage. It is important to act quickly to minimize exposure to your home.



247 Emergency Leak Detection

Get Emergency Plumbing Help!







What does a slab leak look like?


If you can see the pipe, even a small leak is easy to trace. Slab leaks occur in the pipes buried deep in the concrete foundation of your home meaning that is not always visible.


How can I tell if I have a slab leak?

Although it may not be possible to see the slab leak you can use the following techniques to diagnose an unseen leak:

  1. Unusually High Water Bills – even the smallest hole in a water pipe can lose thousands of gallons per month. Check your water bill increased usage you cannot explain.
  2. Sound of Running Water – if you can hear water moving quickly through the pipes when faucets & appliances are off, you may have an issue.
  3. Moving Water Meter – If all appliances and faucets in the house are turned off and the meter is stil moving, you could have a problem.
  4. Standing Water or Saturated Ground - If a leak is left undetected for a long time, water can create a damp patch on the floor
Slab Leak Repair


What causes a slab leak?


While copper pipe is regarded as a reliable and long-lasting plumbing material, it can still fail. Some of the most common causes include:

Slab Leak Broken Copper Pipe
  1. Age - as a pipe gets older leaks become more likely. Our experience shows that homes over 25 years old are more likely to suffer a slab leak, but homes of any age can be affected.
  2. Incorrect Installation – if the pipe was bent or damaged when installed, problems can occur in later years.
  3. Temperature Changes - as the slab increases & decreases the pipes expand and contract. Vibration or or edges rubbing against the pipe can create holes.

Whatever the reason for the slab leak, it is important that the problem is found and repaired by a qualified plumber. This will prevent further, more expensive issues.


How can I find a slab leak?


Generally it is pretty easy to use the hot water line to find the general area of a slab leak. A hot spot on the floor will give the approximate location, allowing for us to quickly find the accurate location using a leak detector. Cold-water line leaks present a much more challenging issue to locate. Because the pipe is buried, we must use an electro-acoustic leak detection device so we can ‘hear’ where the issue is. Our equipment reveals the exact location of the leak in the slab. We avoid digging up your floor to find the issue by using the latest electronic leak detection equipment. Finding the exact location can greatly reduce the time and cost of the repair.


What is slab leak detection & how does it work?


Slab leak detection uses electronic equipment to locate the source of the leak. The flow of water and size of the hole gives the leak a unique sound at a customized frequency. The sound is picked up by the detector and used to locate the problem. Sounds traveling through the slab helps us isolate the issue and avoid digging up your floor. Non-destructive and non-invasive techniques are our specialty.


How do I repair a slab leak?


Once you know you have a slab leak, you have choices for repair. If the pipes are easily accessible we can make a direct repair, but this is rarely the case with slab leaks. We do not usually recommend digging up the floor to repair the leak as this can move the pipe and cause more problems in the future. Instead, a new pipe can be routed through the framework of the house isolating the area with leak.


Slab Leak Repair Service


Water damage restoration, repiping, and detection and slab leak repairs take a variety of skills. As licensed contractors our plumbers at 247 LeakMasters are able to handle the size and scope of any job. Don’t worry about dealing with your insurance company. We will help you every step of the way.



If you suspect you have slab leak it is important to have a professional diagnose it right away to keep damage and costs down. We truly are 24/7. We have 60 minutes response times for Burlingame plumbing emergencies. We are ready to help! As a family owned, run and operated local business, we have over 20 years experience as the slab leak repair experts! Call today for your peace of mind!