phone icon855-647-5944

We Bill Insurance!

Family Owned And Operated for over 20 years!

clock with 24 and 7 near the hands

60 Minute Response! phone icon 855-647-5944 Emergency Plumbing Help


Slab Leak Repair Northwood Point



Think you have a slab leak in your Northwood Point home or business? When it comes to Slab leak detection in Northwood Point, 247 LeakMasters a local and family owned business is your go to solution. 247 LeakMasters expert plumbers use the very latest in leak detection technology to diagnose the source of a leak so we can fix the problem and repair all of your flood or water damage. Our expertise allows for us to repair your leak with the minimal amount of damage.

We are not just plumbers but fully licensed contractors, this allows us to perform any necessary repairs. We are insurance specialists, working directly with your insurance company so you don’t have to.

We do not charge for call outs. Call us today to find out how your detection could be FREE! We can be with you in less than 60 minutes! In addition to fixing your slab leak we provide full service water damage restoration for Northwood Point homes. If you think you may have a slab leak, don’t delay, call us today!

Slab Leak Repair in Northwood Point

What is a slab leak?

The plumbing systems in many properties in Northwood Point were installed with copper piping buried in the large concrete foundation. Copper pipes are know to be susceptible to developing cracks and holes as time goes on. Since the leak source is under concrete and is not easily detectible, by the time you notice the issue it has caused damage already. This is what is known as a slab leak. If you suspect you have a slab leak, it is important to act quickly and avoid any further damage to your home.



247 Emergency Leak Detection

Get Emergency Plumbing Help!







What does a slab leak look like?


If you can see the pipe, even a small leak is easy to trace. Slab leaks occur in the pipes buried deep in the concrete foundation of your home meaning that is not always visible.


How can I tell if I have a slab leak?

Although it may not be possible to see the slab leak you can use the following techniques to diagnose an unseen leak:

  1. Unusually High Water Bills – even the smallest hole in a water pipe can lose thousands of gallons per month. Check your water bill increased usage you cannot explain.
  2. Sound of Running Water – if you can hear water moving quickly through the pipes when faucets & appliances are off, you may have an issue.
  3. Moving Water Meter – If all appliances and faucets in the house are turned off and the meter is stil moving, you could have a problem.
  4. Standing Water or Saturated Ground - If a leak is left undetected for a long time, water can create a damp patch on the floor
Slab Leak Repair


What causes a slab leak?


While copper pipe is regarded as a reliable and long-lasting plumbing material, it can still fail. Some of the most common causes include:

Slab Leak Broken Copper Pipe
  1. Age - as a pipe gets older leaks become more likely. Our experience shows that homes over 25 years old are more likely to suffer a slab leak, but homes of any age can be affected.
  2. Incorrect Installation – if the pipe was bent or damaged when installed, problems can occur in later years.
  3. Temperature Changes - as the slab increases & decreases the pipes expand and contract. Vibration or or edges rubbing against the pipe can create holes.

Whatever the reason for the slab leak, it is important that the problem is found and repaired by a qualified plumber. This will prevent further, more expensive issues.


How can I find a slab leak?


Finding the general area of a slab leak from the hot water line is straightforward. A hot spot on the floor will give the approximate location, allowing for us to quickly find the accurate location using a leak detector. Cold-water line leaks present a much more challenging issue to locate. Because the pipe is buried, we must use an electro-acoustic leak detection device so we can ‘hear’ where the issue is. We use specialized devices that show us with pinpoint accuracy where the slab leak is located. We avoid digging up your floor to find the issue by using the latest electronic leak detection equipment. Pinpoint accuracy helps us reduce time and costs for your repair.


What is slab leak detection & how does it work?


Slab leak detection uses electronic equipment to locate the source of the leak. Water flow and hole size cause a sound to be emitted with a unique frequency by the leak. The equipment isolates the sound and locks on to the issue location. We avoid digging up the floor to find the issue because the sound travels through the slab. Our operations don't cause damage and are non-invasive.


How do I repair a slab leak?


Once you know you have a slab leak, you have choices for repair. If the pipes are easily accessible we can make a direct repair, but this is rarely the case with slab leaks. We do not usually recommend digging up the floor to repair the leak as this can move the pipe and cause more problems in the future. Instead, a new pipe can be routed through the framework of the house isolating the area with leak.


Slab Leak Repair Service


The skills required for slab leak repair; detection, re-piping and water damage restoration are vast. All or our plumbers are also licensed and insured contractors who can take on the task. Homeowners insurance can seem scary. Our friendly staff are experts at dealing directly with your homeowners insurance and will be with you every step of the way.



The more time that goes by before identifying a slab leak generally correlates to increased damage and repair fees. We are always ready to help! Our plumbing technicians can be at your Northwood Point home in 60 minutes any day of the week regardless of what time it is. We are a family owned local business that has been providing slab leak repair services for more than 20 years. Call us now!