phone icon855-647-5944

We Bill Insurance!

Family Owned And Operated for over 20 years!

clock with 24 and 7 near the hands

60 Minute Response! phone icon 855-647-5944 Emergency Plumbing Help


Slab Leak Repair Washington



Have you been told you have a slab leak in Washington? Family operated and local to Washington, 247 LeakMasters is your number 1 choice for slab leak detection. Our plumbing technicians use the latest leak detection equipment to find the source and repair the pipe & any water or flood damage. We figure out the best way to fix the leak without digging a big hole in your floor.

We are not just plumbers but fully licensed contractors, this allows us to perform any necessary repairs. We interface directly with your insurance provider so you can focus on more important things!

We do not charge for call outs. Call us today to find out how your detection could be FREE! We can be with you in less than 60 minutes! In addition to fixing your slab leak we provide full service water damage restoration for Washington homes. If you think you may have a slab leak, don’t delay, call us today!

Slab Leak Repair in Washington

What is a slab leak?

Most Washington homes have copper piping under a concrete slab type foundation. Copper pipes are know to be susceptible to developing cracks and holes as time goes on. This leads to what is known as a slab leak. Because the leak source is not visible by the time you actually see the water damage can be extensive. Slab leaks can cause substantial damage. It is important to act quickly to minimize exposure to your home.



247 Emergency Leak Detection

Get Emergency Plumbing Help!







What does a slab leak look like?


If you can see the pipe, even a small leak is easy to trace. Slab leaks occur in the pipes buried deep in the concrete foundation of your home meaning that is not always visible.


How can I tell if I have a slab leak?

Although it may not be possible to see the slab leak you can use the following techniques to diagnose an unseen leak:

  1. Unusually High Water Bills – even the smallest hole in a water pipe can lose thousands of gallons per month. Check your water bill increased usage you cannot explain.
  2. Sound of Running Water – if you can hear water moving quickly through the pipes when faucets & appliances are off, you may have an issue.
  3. Moving Water Meter – If all appliances and faucets in the house are turned off and the meter is stil moving, you could have a problem.
  4. Standing Water or Saturated Ground - If a leak is left undetected for a long time, water can create a damp patch on the floor
Slab Leak Repair


What causes a slab leak?


While copper pipe is regarded as a reliable and long-lasting plumbing material, it can still fail. Some of the most common causes include:

Slab Leak Broken Copper Pipe
  1. Age - as a pipe gets older leaks become more likely. Our experience shows that homes over 25 years old are more likely to suffer a slab leak, but homes of any age can be affected.
  2. Incorrect Installation – if the pipe was bent or damaged when installed, problems can occur in later years.
  3. Temperature Changes - as the slab increases & decreases the pipes expand and contract. Vibration or or edges rubbing against the pipe can create holes.

Whatever the reason for the slab leak, it is important that the problem is found and repaired by a qualified plumber. This will prevent further, more expensive issues.


How can I find a slab leak?


Hot water lines associated with slab leaks make them easier to find. A hot spot on the floor will give the approximate location, allowing for us to quickly find the accurate location using a leak detector. Locating a cold water-line leak is very challenging. Electronic leak detection equipment is required so we can ‘listen’ to buried pipes. Our equipment reveals the exact location of the leak in the slab. Modern electronic leak detection equipment means you do not have to dig into the floor to find the problem. Time and costs are reduced because we identify exactly where the repairs need to be done.


What is slab leak detection & how does it work?


The source of the leak requires electronic equipment that is made for slab leak detection. Sounds are emitted at varying frequencies from leaks depending on the size of the hole and the flow of the water. The problem is located when the detector picks up the sound. We don't dig up your floor to search for the problem because we can detect the sound coming through the slab. The entire operation is non-invasive & non-destructive.


How do I repair a slab leak?


Once you know you have a slab leak, you have choices for repair. If the pipes are easily accessible we can make a direct repair, but this is rarely the case with slab leaks. We do not usually recommend digging up the floor to repair the leak as this can move the pipe and cause more problems in the future. Instead, a new pipe can be routed through the framework of the house isolating the area with leak.


Slab Leak Repair Service


Water damage restoration, repiping, and detection and slab leak repairs take a variety of skills. 247 LeakMasters are licensed plumbers and contractors, able to handle the complete job. Homeowners insurance can seem scary. Our friendly staff are experts at dealing directly with your homeowners insurance and will be with you every step of the way.



The more time that goes by before identifying a slab leak generally correlates to increased damage and repair fees. We are always ready to help! Our plumbing technicians can be at your Washington home in 60 minutes any day of the week regardless of what time it is. As a family owned, run and operated local business, we have over 20 years experience as the slab leak repair experts! Call today for your peace of mind!